01E1

SET_CHAR_OBJ_FOLLOW_ROUTE

---

Description

Sets the character's objective to follow a route

Syntax

01E1: set_actor [char handle] follow_route [int1] [int2]

Parameter

[char handle]

The handle of the character

[int1]

Route

[int2]

Mode (see below)

This opcode sets the character's objective to walk along a route created by opcode 01E2. If the path is obstructed, the character cannot complete the route. When used on the player character, the player character becomes uncontrollable as it follows the route. Entering a vehicle, getting wasted, or getting busted regains control of the player character. Assigning certain objectives or clearing it using opcode 011C will stop any character from following the route.

Follow route modes

Mode	Enum	Notes
0	FOLLOW_ROUTE_INVALID	Walks straight to the center of the map (0,0)
1	FOLLOW_ROUTE_ONCE	Follows the route once, then walks straight to the center of the map (0,0)
2	FOLLOW_ROUTE_BACKFORWARD	Follows the route in loop, when reaches the end walks back, e.g. 1,2,3,4,3,2,1,2,3,...
3	FOLLOW_ROUTE_LOOP	Follows the route in loop, when reaches the end starts at the beginning, e.g. 1,2,3,4,1,2,3,4,1,...

Any values outside this range will act like value 0.

Keywords

set, actor, character, ped, follow, route, path